कृषि उपकरणों की विश्वसनीय कंपनी

A pre-season maintenance checklist for your rotavator

A pre-season maintenance checklist for your rotavator

A rotavator works in the harshest conditions on the farm — dust, stones, wet clay and long hours. A short check before the season starts keeps it cutting cleanly and protects the gearbox, which is the most expensive part to repair.

1. Blades and bolts

Look at every blade. Replace blades that are bent, cracked or worn thin, and always replace them in matching sets so the rotor stays balanced. Tighten every blade bolt to the recommended torque.

2. Gearbox and side transmission oil

Check the oil level in the main gearbox and the side gear housing. If the oil looks milky or has metal particles in it, drain and refill it, and have the seals inspected.

3. Oil seals

Oil around the rotor ends or the gearbox means a seal is failing. Replacing a seal early is far cheaper than replacing bearings or gears later.

4. PTO shaft and safety guard

Grease the PTO shaft joints, check that the telescopic tubes slide freely, and make sure the safety guard is in place and not cracked.

5. Hitch pins, springs and the levelling board

Check the three-point hitch pins and linch pins, the damper springs and the rear levelling board. A loose board leaves an uneven finish.

6. Grease every nipple

Grease all points listed in your operator manual. Wipe off old dirty grease first.

After the season

Wash off mud and residue, touch up bare metal with paint, oil the blades lightly to prevent rust, and store the machine under a roof on a stand. If you need spare blades, seals or a service visit, contact our team with your model and serial number.